Operation Manual

90 MS 241 C
: Push starter rope (1) out a short
distance and undo the knot
– Pull starter rope out of rope rotor
and fan housing.
: Tie one of the two special knots
shown above at the end of the
rope in the starter grip.
: Thread the new starter rope into
the starter grip from above
2310RA215 TG
1
165RA227 TG
4903RA131 TG
Pull the rope through the grip until
the knot at the end of the rope is in
the recess (arrow)
: Then thread the rope (1) through
the opening (arrow)
: Thread starter rope (1) into rope
rotor
– Secure the rope (1) with a simple
overhand knot
4903RA132 TG2310RA216 TG
1
2310RA217 TG
1
: Pull starter rope (1) into rotor until
the knot rests in the
recess (arrow) of the rope rotor
– Tension the rewind spring, b 9.7
– Reassemble remaining parts in
reverse order
9.7 Tensioning the rewind
spring
– Remove fan housing and
segment, b 9.2
: Pull out part of the starter rope (1)
: Turn starter rope (1) with rope
rotor (2) six times clockwise
The rewind spring is now tensioned.
Hold the tensioned rope rotor firmly,
as the rewind spring will be
damaged if it jumps back suddenly.
2310RA218 TG
1
2310RA219 TG
1
2