Operation Manual

89MS 241 C
9.5 Rope rotor
Relieve tension of rewind spring
The system will not be under
tension if the starter rope or rewind
spring is broken.
– Remove fan housing and
segment, b 9.2
Versions with ErgoStart
– Remove ErgoStart, b 9.4
All versions
: Pull out the starter rope (1)
about 5 cm, then hold the rope
rotor (2) steady
– Still holding the rope rotor steady,
take three full turns off the rope
rotor
– Pull out the rope with the starter
grip and carefully release the
rope rotor
– Remove the starter rope; remove
any remaining scraps of rope,
b 9.6
– Remove spring and pawl or
pawls, b 9.3
2310RA212 TG
2
1
: Remove the washer (1)
The rewind spring must be relieved.
: Carefully pull off the rope rotor (2)
–The rewind spring may pop out
– Examine the rope rotor, replace if
necessary.
– Coat the hole in the rope rotor
with STIHL special lubricant,
b 16
Installation
: Fit the rotor on the starter post so
that the inner loop of the
spring (arrow) enters the
recess (1)
The recess in the hub of the rope
rotor acts as carrier for the anchor
loop.
– Fit the washer.
2310RA213 TG
2
1
2310RA214 TG
1
– Install pawl or pawls and spring,
b 9.3
– Install starter rope, b 9.6
– Tension the rewind spring, b 9.7
– Grease the pegs of the pawl or
pawls, b 16
– Reassemble remaining parts in
reverse order
9.6 Starter rope / starter grip
– Remove fan housing and
segment, b 9.2
Versions with ErgoStart
– Remove ErgoStart, b 9.4
All versions
– Relieve the tension of the rewind
spring, b 9.5
The rewind spring will not be under
tension if the starter rope is broken.
– Remove any remaining rope from
the rope rotor if necessary
The starter rope must not be
shortened.