Operation Manual

88 MS 241 C
9.4 ErgoStart
The spring may still have spring
tension stored in it, thus release the
spring tension before any assembly
procedure:
– Pull out the starter until the
engine turns – the preloaded
spring is relaxed
– Remove fan housing and, if
necessary, segment, b 9.2
: Remove the circlip (1)
: Remove washer (2) and
carrier (3)
: Remove spring housing (4)
: Push out circlips (arrows)
: Pull out pawls (1) and remove
torsion springs
– Clean the mounts of the
pawls (1), b 16
2310RA209 TG
3 2 1
4
2710RA165 TG
1
1
Installation
: Install torsion springs in pawls (1)
– observe installation
position (arrows)
: Push pawls (1) onto the posts (2)
on the flywheel, in the process
pretensioning the torsion springs
and positioning them on the
support ribs (arrow)
: Push on the pawls (1) so that
they can move towards the
middle of the flywheel as far as
they will go
: Push circlips (2) into place
533RA198 TG
1
1
5902RA581 TG
2
1
2710RA274 TG
2
1
Checking correct functioning
The pawls must move freely and
rest against the stop due to the
spring force.
: Push spring housing (1) over the
rope rotor post into the pawls of
the rope rotor (2) – the pawls
must engage in the spring
housing
: Insert the carrier (1) in the spring
housing so that the
recess (arrow) engages the
anchor loop (2) of the rewind
spring
: Fit washer (3)
: Fit the circlip (4)
– Do not overextend circlip
– Reassemble remaining parts in
reverse order
2310RA210 TG
2
1
2310RA211 TG
2 1 3 4