Operation Manual

81MS 241 C
8.5.2 Engine does not start in
position }
Is it possible to start
the engine?
Troubleshooting completed
– Check start detection
(microswitch actuation)
clean if necessary
– Examine switch gear,
clean or replace if
necessary, b 8.2.5, b 8.4
– Check start detection,
wiring harness and plug
connections,
b 8.2.5,b 8.2.3
yes
Mechanically
OK?
Are target values
attained?, b 8.2.5
– Look for a fault in the fuel
path (inlet needle, lever,
spring, membrane),
check engine for leaks,
b 13.11, b 6.2
– Examine switch gear and/
or wiring harness, clean or
replace if necessary,
b 8.2.5, b 8.2.3
yes
no
no
Engine does not start in
position } – engine floods.
Can the flooded engine be
started in position F?
yes
no