Operation Manual

79MS 241 C
Versions with heating
: Press thermostatic switch
lead (1) completely into the
guide (arrow) of the air guide
shroud
– Lead (1) must form a loop at the
plug connection
: Slide the heating element (1)
over the studs so that the hole
engages the pin (2)
: Orient the crimped side of the
blade receptacle (3) so that it
faces the carburetor
: Push the blade receptacle (3)
completely onto the connector
tab (arrow)
2410RA257 TG
1
1
2410RA258 TG
3
2
Versions with manual fuel pump
: Push the holder (1) with the fuel
pump into the mount of the air
guide shroud (2) as far as it will
go; push new fuel hose (3) onto
the connectors (arrows)
: Fuel return line (4) must be
seated completely in the
guide (5); if necessary, press the
fuel return line (4) into the
guide (5) again
3
2410RA259 TG
1
2
4
5
All versions
: Push the holder (1) of the
switchgear over the studs so that
the tab rests against the
pin (arrow)
– Install filter base, b 13.3
– Reassemble remaining parts in
reverse order
2410RA260 TG
1