Operation Manual

77MS 241 C
The fuel hose does not have to be
removed from the carburetor
support.
: Carefully pull out the carburetor
with the fuel hose over the studs
and lay it aside – do not
overextend the fuel hose
: Turn the throttle shaft lever (1)
slightly in the direction of full-
throttle, then turn the starter
shaft (2) until the choke shutter is
closed
: Disconnect the plug (1) from the
solenoid valve (2) – the solenoid
valve must not be twisted; if
necessary, hold the solenoid
valve in place when
disconnecting the plug
2410RA244 TG2410RA245 TG
2
1
2410RA246 TG
2
1
: Pull the wiring harness (1) out of
the guide (arrow) and pull it out
between the special bolt (2) and
the starter shaft (3)
: Check lever on the starter
shaft (3), replace if necessary,
b 13.6.6
Installation
With a new switchgear, first the
leads must be inserted in the guides
of the switchgear.
Leads and plug connections must
not be damaged.
: Press red lead (1) and black
lead (2) completely into the
guides (arrows) of the
switchgear (3)
– see illustration
2410RA247 TG
21
3
2410RA248 TG
1
2
3
: Orient plug (1) so that the guide
pin (arrow) faces the carburetor
: Push the plug (1) into the jack of
the solenoid (2) as far as it will go
: Orient wiring harness (1) so that
the red lead runs underneath the
black lead
Choke shutter must be closed.
: Guide wiring harness (1)
between the special bolt (2) and
the starter shaft (3)
2410RA249 TG
2
1
2410RA250 TG
21
3