Operation Manual

76 MS 241 C
8.3 Wiring harness
– The M-Tronic leads and the
ground wire are all combined into
one wiring harness; removal and
installation are described in the
chapter "Short-circuit wire",
b 7.7.2
8.4 Switchgear
– Remove shroud, b 6.4
– Remove the air filter, b 13.1
– Check switchgear, b 8.2.5
– Remove choke rod, b 11.4
– Remove baffle, b 13.2
– Remove filter base, b 13.3
: Pull holder (1) of the switchgear
over the studs (arrows) and lay it
aside
2410RA239 TG
1
Versions with heating
: Remove blade receptacle (1)
: Remove heating element (2)
from the studs
Versions with manual fuel pump
: Disconnect the fuel hose (1)
: Push out the holder (1) with the
fuel pump on the air guide
shroud (2) and lay it on top of the
air guide shroud
2
2410RA240 TG
1
2410RA241 TG
1
2410RA242 TG
1
2
All versions
: Pull plug connector (1) out of the
carburetor support mount (arrow)
: Hold the jack (1), press the
tab (arrow) and pull out the
plug (2) – do not tug on the leads
2410RA243 TG
1
2410RA172 TG
2 1