Operation Manual

ManualsBrandsSTIHL ManualsChainsawsSTIHL MS 241 C-M

65MS 241 C

: Press contact sleeve (1) of the

short-circuit wire out of the

contact spring (2)

– Examine contact spring, replace

if necessary

Installation

: Push the contact sleeve (1) of the

short-circuit wire into the

eye (arrow) of the contact

spring (2) as far as it will go

2410RA210 TG

2

1

2410RA211 TG

1

2

: Position contact spring (1)

against the guide (arrows)

: Lift contact spring (1) slightly at

the connection of the short-circuit

wire and guide it over the tab (2)

– do not overextend the contact

spring

Before pushing the contact

spring (1) all the way in, lift it slightly

and guide it over the switch shaft –

2 mm maximum.

2410RA212 TG

2

1

2310RA153 TG

1

: Push the contact spring (1) into

the guide (arrows) as far it will go,

until the tab surrounds the

contact spring

– Install filter base, b 13.3

: Checking correct functioning

– Blade receptacle of the short-

circuit wire must touch the

contact spring (arrow) in position

"

0"

– Reassemble remaining parts in

reverse order

2310RA154 TG

1

2310RA155 TG