Operation Manual

63MS 241 C
Versions with heating
: Orient blade receptacle (1) so
that the crimped side faces the
carburetor
: Press blade receptacle (1) onto
the connector tab (arrow) of the
heating switch as far as it will go
: Press carburetor heating lead (1)
completely into the guide (arrow)
Versions with manual fuel pump
: Push the holder (1) with the fuel
pump into the recess in the air
guide shroud (2) as far as it will
go
2410RA198 TG
1
2410RA169 TG
1
3
2410RA226 TG
1
2
: Press fuel return line (3)
completely into the guide (arrow)
Push the new fuel suction hose (1)
completely onto the
connectors (arrows)
All versions
Ground wire: Crimped side of the
cable lug (1) must be visible.
: Position cable lug (1) between
control unit (2) and stop (3)
: Insert screw (4) with washer and
tighten
1
2410RA227 TG2410RA203 TG
1
42 3
: Press ground wire (1) completely
into the guide (arrow)
– Ground wire is routed
underneath the wiring harness
: Orient angled plug (1) so that the
retaining tab (2) faces the muffler
: Press the angled plug (1) straight
onto the connector tags until the
retaining tab (2) snaps into place
– Do not insert the angled plug on
a slant or tilt it
2410RA204 TG
1
2410RA205 TG
1
2