Operation Manual

61MS 241 C
: Press the red M-Tronic lead (1),
ground wire (2) and black
lead (3) of the short-circuit wire
all the way into the
guides (arrows)
The protective tube (4) must start at
the beginning of the rib and
protective tube (5) must rest against
the beginning of the rib.
: Slide cable holder (1) with the
hinge into the slot (arrow) of the
air guide shroud
: Turn the cable holder (1) towards
the cylinder and position it
2410RA190 TG
1
3 2
4
5
2410RA191 TG
1
: Check that the leads are properly
seated in the guides and press
the cable holder (1) with the
pin (arrow) into the mount until it
snaps into place
: Orient diagnostic jack (1) so that
the black leads (2) face the
control handle
: Press diagnostic jack (1) and
connector housing (3) into the
guides (arrows)
2410RA192 TG
1
2410RA193 TG
1
2
3
: Press the diagnostic jack (1) into
the mount so that it is seated
completely in the recess (arrows)
and the tabs (2) snap into place
: Press plug (1) into the mount as
far as it will go
: Using wiring tool 5910 890 4000,
press the blue ground wire (1)
and black short-circuit wire (2)
into the guide (arrow) so that the
wires are snug against the air
guide shroud
2410RA194 TG
2
2
1
2410RA195 TG
1
2410RA196 TG
1
2