Operation Manual

52 MS 241 C
: Remove screws (1) with washers
– Remove control unit
: Remove wiring harness (1) and
ground wire (2) from the
guides (arrows) and remove
cable holder (3)
– Check ignition lead, replace if
necessary
– Examine the spark plug boot,
replace if necessary, b 7.5
– Troubleshooting, b 3.5
2410RA146 TG
1
1
2410RA147 TG
1
3
2
Installation
: Position cable holder (1) on the
cylinder and secure it with the
pins on the cylindrical raised
parts
: Hold cable holder (1) against
cylinder and position control
unit (2)
: Insert screw (3) with washer – do
not tighten
On the cable lug of the ground wire,
the crimped side must face the
screw head.
2410RA148 TG
1
2410RA149 TG
1
3
2
: Position ground wire (1) so that
the cable lug is pressed fully
home (arrow) and the crimped
side faces the screw head
: Insert screw (2) with washer – do
not tighten
: Push back ignition module and
slide setting gauge (1)
1111 890 6400 between the legs
of the ignition module and the
magnetic poles of the flywheel
2410RA150 TG
1
2
2410RA151 TG
1