Operation Manual

45MS 241 C
– By turning it, screw the spindle
completely into the assembly tool
: Screw the threaded sleeve (1)
5910 893 2409 onto the spindle
as far as it will go
– Left-hand thread
: Fit threaded sleeve on crankshaft
stub (arrow) and push assembly
tool over the studs
165RA133 TG
1
0001RA494 TG
: Hold crankshaft steady and
screw threaded sleeve onto
thread of crankshaft stub by
turning the spindle
counterclockwise
– Release crankshaft and hold
assembly tool steady and
continue turning the spindle until
the assembly tool rests against
the crankcase half.
– Screw nut onto the stud and
tighten it by hand
: Turn spindle (1)
counterclockwise until the
crankcase half rests against the
guide sleeves
2410RA121 TG2410RA122 TG
1
Ensure that the guide
sleeves (arrows) line up with the
holes and that the housing gasket is
not jammed or buckled.
– Continue turning the spindle of
the assembly tool until the gap
between the halves of the
crankcase is closed
– Unscrew nuts
– Turn the spindle clockwise to
remove the assembly tool
– Remove the two M5x72 screws
which were fitted to prevent
twisting
: Insert the screws (arrows) and
tighten them down crosswise
2410RA119 TG2410RA107 TG