Operation Manual

41MS 241 C
: Remove clamping strap (1) and
wooden assembly block (2)
Make certain that the cylinder
gasket is oriented according to the
holes.
– Push cylinder home as far as
possible
: Fit screws (arrows) and secure
cylinder with gasket
: Tighten down the screws through
the holes (arrows) crosswise
– Reassemble remaining parts in
reverse order
2410RA104 TG
2
1
2410RA093 TG
6.6 Crankshaft
– Drain fuel tank and oil tank,
b 1.1
– Remove brake band, b 5.2
– Remove oil pump, b 12.3
– Remove oil suction hose,
b 12.2
– Remove brake lever, b 5.3
QuickStop Super, b 5.4
– Remove the front handle,
b 10.4
Version with heating, b 10.4.1
– Remove the tank housing,
b 13.11.5
– Remove the flywheel, b 7.6
– Version with handle heating
Remove generator, b 14.7
– Remove the cylinder, b 6.5
– Remove piston, b 6.7
– Remove spiked bumper
Always fit new ball bearings and oil
seals when removing the
crankshaft, b 6.6.1 and b 6.3.
Clutch side half of crankcase
: Remove the circlip (1)
The tools from the assembly tool kit
5910 007 2205 are used for
removal and installation.
: Take out the screws (arrows)
: Remove screws (1) and pull out
chain tensioner (2)
2410RA106 TG
1
2410RA107 TG2410RA105 TG
21