Operation Manual

38 MS 241 C
Avoid damage to the crankshaft
stub.
– Free the oil seal in its seat by
tapping it with a suitable tube or a
punch.
: Position puller (1) 5910 890 4400
– Clamp the puller arms
– Pull out the oil seal
Installation
– Clean the mating surface, b 16
– Grease the sealing lips of the
new oil seal, b 16
: Fit the installing sleeve (1)
1141 893 4600
: Slide the oil seal (2) over the
installing sleeve with the sealing
lip facing the crankcase
2410RA086 TG
1
2410RA087 TG
2
1
: Remove the installing sleeve (1)
: Orient press sleeve (1)
1118 893 2401 with the
collar (arrow) facing the engine
: Use the press sleeve (1)
1118 893 2401 to install the oil
seal (2)
The seating face must be flat and
free from burrs.
: Fit the circlip (1)
– Reassemble remaining parts in
reverse order
2410RA088 TG
2
1
1
2410RA089 TG
6.4 Shroud
: Release quick release
locks (arrows)
– Using the combination wrench,
turn 1/4 turn counterclockwise
: Remove the shroud (1)
: Push out cap (arrow) with drift (1)
2410RA090 TG
1
2410RA091 TG
1