Operation Manual

32 MS 241 C
5.7.2 Chain catcher
– Remove the chain sprocket cover
: Remove screw (1) and pull out
chain catcher (2) under the
bumper strip
– Reassemble parts in reverse
order
5.8 Bar mounting stud
– Remove the chain sprocket cover
: Push stud driver (1)
5910 893 0501 onto the stud (2)
as far as it will go and unscrew
counterclockwise
– Coat stud with Loctite, screw in
and tighten, b 16
2410RA300 TG
2
1
2410RA065 TG
2
1
– Reassemble remaining parts in
reverse order
5.9 Collar nut for chain
sprocket cover
This chain sprocket cover can only
be used on the MS 241.
It cannot be retrofitted to other
models. The length and shape of
the stud must be appropriate for the
chain sprocket cover with captive
nut.
The special tool stud
5910 893 9600 is available for
replacing the nut.
– Remove the chain sprocket cover
: Screw the assembly tool (1)
5910 893 9600 with the short
stud into the collar nut (2) as far
as it will go
2410RA066 TG
12
– Flip over the chain sprocket cover
and clamp the assembly tool into
a vise by the hexagon
: Drill out the collar nut with an
11 mm diameter drill bit – the
base in the chain sprocket cover
must not be drilled out
– Pull out the collar nut
– Unscrew the assembly tool from
the collar nut
2410RA067 TG