Operation Manual

30 MS 241 C
Installation
– Coat the knurled area of the new
pin with Loctite before fitting the
pin, b 16
: The pin must be inserted in the
hole (arrow) so that the knurling
on the pin engages the knurled
profile
Turn the pin back and forth slightly
until it fits.
The pins must be driven in square.
: Drive in pins (1) and (2) in
accordance with the following
information
2410RA054 TG2410RA055 TG
2
1
: Pin (1) a = approx. 2.9...3.3 mm
Pin (2) b = approx. 4.3...4.7 mm
: Drive in anchor pins (3), (4)
and (5) in accordance with the
following information
: Pin (3) a = approx. 8.9...9.1 mm
Pin (4) b = approx. 4.6...4.8 mm
Pin (5) c = approx. 5.1...5.3 mm
a
b
0001RA061 TG
1
2
2410RA056 TG
3
4 5
a
c
b
3
4
5
2410RA057 TG
Machines with QuickStop Super
: Drive in anchor pins (5) and (6) in
accordance with the following
information
: Pin (5) b = approx. 5.1...5.3 mm
Pin (6) a = approx. 2.9...3.3 mm
– Reassemble remaining parts in
reverse order
– Grease brake and cam levers,
b 16
2410RA058 TG
6
5
a
b
2410RA059 TG
6
5