Operation Manual

29MS 241 C
: Examine cam lever (1) and brake
spring (2) and replace if
necessary
: Check condition of cam
guide (arrow) and replace hand
guard if necessary
– Examine all pins and replace if
necessary,
b 5.6
Installation
– Clean pins and disassembled
parts, b 16
– Grease pins, b 16
: Orient cam lever (1) so that the
cam (arrow) faces the pin (3)
: Slide cam lever (1) onto anchor
pin (2)
2410RA049 TG
1
2
2410RA050 TG
3
1
2
: Push circlip (1) into place
: Hook brake spring (1) into the
brake lever so that the opening of
the anchor loop (arrow) is visible
: Hook brake spring (1) onto
pin (2)
– Grease cam lever, b 16
The cam lever is not yet tensioned –
the spring may become detached
again.
– Reassemble remaining parts in
reverse order
2410RA051 TG
1
2410RA052 TG
2
1
5.6 Pins
The pins ensure that the springs are
securely mounted. They must
therefore be replaced when worn,
otherwise the springs may pop out.
The pins must be driven in square.
For reasons of simplicity, the parts
connected to the pins have already
been removed in the following
illustrations.
: Remove pins (1) through (6)
Item 6 is present only in the version
with QuickStop Super.
2410RA053 TG
132
6
54