Operation Manual

28 MS 241 C
: Push brake cable (1) with sleeve
into the hole in the
housing (arrow) as far as it will go
: Hook brake cable (1) into
hole (arrow) in brake lever (2)
: Press brake cable holder with the
pin (1) through the opening and
into the mount (arrow)
: Screw in the screw (2) and
tighten it
2410RA043 TG
1
2410RA044 TG
1 2
1
2
2410RA045 TG
When raising the tank housing,
make certain that the sleeve (1) is
pushed completely into the
adjusting screw (2) – incomplete
insertion of the sleeve changes the
setting of the brake cable.
– Check position of the fuel hose
and correct it if necessary,
b 13.11.2
– Check position of the fuel return
line and correct it if necessary,
b 13.11.3
– Raise and fasten the
tank housing, b 13.11.2
: Insert brake cable (1) in
guide (arrow)
– Install QuickStop Super trigger
switch, b 11.3.1
– Install QuickStop Super throttle
trigger, b 11.3
2
2410RA046 TG
1
1
2410RA047 TG
– Reassemble remaining parts in
reverse order
– Adjust brake cable and check
operation, b 5.4.1
5.5 Cam lever
The cam lever defines the engaged
position of the hand guard.
– Remove brake lever, b 5.3,
QuickStop Super, b 5.4
: Unhook the brake spring (1) from
the anchor pin (2)
– Unhook and remove the brake
spring (1) at the cam lever
: Push out circlip (3)
– Remove cam lever
2410RA048 TG
2
1
3