Operation Manual

27MS 241 C
5.4.2 Brake cable
Removal and installation
– Unhook brake spring, b 5.4
– Remove QuickStop Super
throttle trigger, b 11.3
– Remove QuickStop Super trigger
switch, b 11.3.1
: Pull brake cable (1) out slightly
and disconnect it
– Loosen tank housing and lower it,
b 13.11.2
– Do not overextend fuel hose
: Remove screw (1)
: Remove support (2) with brake
cable
2410RA040 TG
1
1
2
2410RA041 TG
: Examine brake cable (1) and
support (2), replace if necessary
Dismantle brake cable and
support
: Unscrew clamping screw (1) and
adjusting screw (2)
: Turn hook (3) so that the angled
part is at the opening (arrow) and
twist it out of the support (4)
Installation
: Turn hook (1) so that it runs along
the support (2) and push it into
the hole (arrow)
2310RA053 TG
1
2
2310RA054 TG
1
2
3 4
1
2
2310RA055 TG
: Push hook (1) through the
support (2) with a gentle twisting
motion
: Turn adjusting screw (1) until the
distance between the hexagon of
the adjusting screw and the
holder is 2 mm
: Screw in the clamping screw (2)
and tighten
: Guide the brake cable (1) over
fuel hose (3) or, in versions with
manual fuel pump, over the fuel
hose (3) and fuel return line (2)
: Push brake cable (1) with short
hook (4) in front through the
hole (arrow) in the crankcase
2310RA056 TG
12
2410RA042 TG
3
2
4
1