Operation Manual

25MS 241 C
: Turn cam lever (1) aside until
cam of hand guard (arrow) slides
past
– Press bearing eye of hand guard
and brake lever onto the anchor
pins
: Check seat of the sleeve (1) at
the brake cable, push completely
into the hole in the
housing (arrow) if necessary
: Hook brake spring (1) into the
brake lever so that the opening of
the anchor loop (arrow) is visible
1
2410RA034 TG2410RA035 TG
1
1
2410RA036 TG
2
: Attach brake spring (1) to anchor
pin (2)
The turns of the brake spring must
be tightly spaced when not installed;
use a new brake spring if necessary.
– Position the protective tube so
that it starts after the
second turn (arrow)
– The pin for the brake spring must
be replaced if it shows signs of
wear at the groove, b 5.6
: Hook brake spring (1) onto brake
lever (arrow)
5902RA040 TG
1
2410RA037 TG
: Use the assembly tool
1117 890 0900 to hook the brake
spring (1) onto the anchor
pin (arrow)
– Grease brake lever, cam lever
and hand guard motion link,
b 16
– Adjust brake cable, b 5.4.1
– Reassemble remaining parts in
reverse order
5.4.1 Adjusting brake cable
If the coasting brake does not
operate properly although the brake
band is intact, it may be necessary
to adjust the brake cable.
– Troubleshooting, b 3.2
– Check condition and play
– Remove chain brake cover,
b 5.2
When the trigger interlock is not
pressed, the brake cable must
be without tension.
1
2410RA025 TG