Operation Manual

24 MS 241 C
: Disconnect brake cable (1)
: Pull brake lever (2) out of hand
guard (1)
– Examine cam lever and replace if
necessary, b 5.5
– Examine pins and replace if
necessary, b 5.6
– Check cam on hand guard,
replace hand guard if necessary
2410RA028 TG
1
2410RA029 TG
2
1
Installation
– Clean pins and disassembled
parts, b 16
– Grease pins, b 16
: Position brake lever (2) so that
mount for brake spring (arrow) is
at the top
: Slide brake lever (2) into recess
in hand guard (1) until the holes
are lined up
: Attach brake cable (1) to
hole (arrow) in brake lever
2410RA030 TG
2
1
2410RA031 TG
1
: Slide hand guard (1) with brake
lever (2) across the machine until
it rests against the anchor
pins (arrows)
: Slightly lift up bearing eye of the
hand guard (1) and brake
lever (2)and guide the parts over
the anchor pins (arrows)
2
2410RA032 TG
1
2
2410RA033 TG
1