Operation Manual

23MS 241 C
The turns of the brake spring must
be tightly spaced when not installed;
use a new brake spring if necessary.
– Position the protective tube so
that it starts after the
second turn (arrow)
– The pin for the brake spring must
be replaced if it shows signs of
wear at the groove, b 5.6
: Hook brake spring (1) into brake
lever (arrow)
5902RA040 TG2410RA023 TG
1
: Use the assembly tool (2)
1117 890 0900 to attach the
brake spring (1) to the anchor
pin (arrow)
– Grease brake lever, cam lever
and hand guard motion link,
b 16
– Reassemble remaining parts in
reverse order
5.4 QuickStop Super brake
lever
– Troubleshooting, b 3.2
– Remove shroud, b 6.4
– Remove fan housing, b 9.2
– Remove brake band, b 5.2
– Block chain brake
The brake spring is now relaxed.
: Use the assembly tool
1117 890 0900 to unhook the
brake spring (1) at the anchor
pin (arrow)
2410RA024 TG
2
1
1
2410RA025 TG
– Unhook and remove the brake
spring at the brake lever
: Unhook brake spring (1) from
anchor pin (arrow)
: Unhook and remove the brake
spring (1) at the brake lever
: Draw hand guard (1) and brake
lever (2) off the anchor
pins (arrows) simultaneously
– Take out hand guard and brake
lever
1
2410RA026 TG
2
2410RA027 TG
1