Operation Manual

22 MS 241 C
: Push out circlip (1)
: Draw hand guard (1) and brake
lever (2) off the anchor
pins (arrows) simultaneously
– Take out hand guard and brake
lever
– Examine cam lever and replace if
necessary, b 5.5
: Pull brake lever (2) out of hand
guard (1)
2410RA015 TG
1
2410RA016 TG
1
2
2410RA017 TG
21
– Examine pins and replace if
necessary, b 5.6
– Check cam on hand guard,
replace hand guard if necessary
Installation
– Clean pins and disassembled
parts, b 16
– Grease pins, b 16
: Position brake lever (2) so that
mount for brake spring (arrow) is
at the top
: Slide brake lever (2) into recess
in hand guard (1) until the holes
are lined up
: Slide hand guard (1) with brake
lever (2) across the machine until
it rests against the anchor
pins (arrows)
2410RA018 TG
1
2
2410RA019 TG
1
2
: Slightly lift up bearing eye of the
hand guard (1) and brake
lever (2) and guide the parts over
the anchor pins (arrows)
: Turn cam lever (1) slightly aside
until cam of hand guard (arrow)
slides past
– Press bearing eye of hand guard
and brake lever onto the anchor
pins
: Push circlip (1) into place
2410RA020 TG
1
2
2410RA021 TG
1
2410RA022 TG
1