Operation Manual

168 MS 241 C
: Slide insulating tubes (1) towards
connecting leads and disconnect
plug connections
– Remove and examine
connecting leads, replace if
necessary
Installation
– Press the plug connection
together completely, b 1
Run all leads under the throttle rod.
: Push insulating tubes (1) onto
both ends of the connecting
leads (2) and (3)
2410RA432 TG
1
1
2410RA433 TG
3
2 1
1
: Connect the thin connecting
lead (1) with the thin lead (2) of
the wiring harness and the lower
lead (3) of the handle heating
element
– Push connectors and socket
terminals together as far as
possible
: Slide insulating tubes (4) over the
plug connections
: Connect the thick connecting
lead (1) with the long lead (2) of
the handlebar and the upper
lead (3) of the handle heating
element
– Push connectors and socket
terminals together as far as
possible
: Slide insulating tubes (4) over the
plug connections
At the handlebar, the long lead must
be run under the shorter lead.
2410RA434 TG
3
4
4
1
2
2410RA435 TG
3
4
1
2
4
: Position insulating tube (1) with
plug connection at the edge of
the tank housing and push it into
the guide (arrow) as far as it will
go
: Position insulating tube (1) with
plug connection at the edge of
the tank housing and push it into
the guide (arrow) as far as it will
go
: Run the thin wire (1) with a
loop (arrow) around the fin and
press it into the guide as far as it
will go
2410RA436 TG
1
2410RA437 TG
1
2410RA438 TG
1