Operation Manual

166 MS 241 C
14.8 Wiring harness
If the wiring harness if faulty, it must
be replaced.
– Remove shroud, b 6.4
– Remove the handle molding and
trigger interlock, b 11.2
– Remove the carburetor, b 13.5
– Remove carburetor support,
b 13.8
– Remove the air guide shroud,
b 13.4.2
– Lower the tank housing and
remove the cover of the plug
connections, b 10.4.1
: Pull plug connections (1) and (2)
with insulating tubes out of the
guides (arrows)
: Push insulating tube (1) and (2)
toward the wiring harness
2410RA417 TG
2
1
2410RA418 TG
2
3
1
: Disconnect plug connections and
remove wiring harness (3)
Installation
– Press the plug connections
together completely, b 1
: Push insulating tubes (1) onto
the wires with the socket
terminal (2) and (3)
Grommet (4) must rest against the
protective tube (5).
: Press plug (1) of handle into the
terminal socket (2) of thick wire
as far as it will go
: Slide on the insulating tube (3)
2410RA419 TG
2
3
1
4
5
1
2410RA420 TG
2 1
3
The wires of the handle must be
seated completely in the
guide (arrow).
: Press the plug (1) of the thin
connecting wire (2) into the
terminal socket (3) of the wiring
harness (4) as far as it will go
: Slide on the insulating tube (5)
: Position insulating tube (1) with
plug connection at the edge of
the tank housing and push it into
the guide (arrow) as far as it will
go
2410RA421 TG2410RA422 TG
5
1 32
4
2410RA423 TG
1