Operation Manual

161MS 241 C
: Lay generator lead (1) in bottom
of recess (arrow)
: Press generator lead (1) into the
guides (arrows) so that it runs
snug against the crankcase
: Pull the generator lead (1)
through the opening (arrow) until
it lies snug against the crankcase
2410RA410 TG
1
2410RA411 TG
1
2410RA412 TG
1
: Press generator lead (1) on the
inside of the crankcase into the
guide (arrow) so that it lies snug
: Push grommet (1) onto the
generator lead (2) so that the
cone (arrow) faces the generator
– Install air guide shroud, b 13.4.2
2410RA413 TG
1
2410RA414 TG
21
The lead (1) must be seated
completely in the recess (arrow).
The flywheel must not touch the
generator lead
– power supply can be interrupted.
– Reassemble remaining parts in
reverse order
2410RA415 TG
1