Operation Manual

156 MS 241 C
14.4 Heating switch
– Remove filter base, b 13.3
: Remove blade receptacle (1)
: Remove contact sleeve (2)
: Unscrew nut (1)
: Remove washer (2)
: Pull heating switch (1) off to the
inside and examine, replace if
necessary
2410RA383 TG
2
1
2410RA384 TG
12
2410RA385 TG
1
: Remove screw (1)
: Remove socket terminal (2) at
the holder (4) and remove
ground wire (3) from the
guide (arrow)
: Check holder (4), if necessary,
remove from the air guide shroud
and replace
: Disconnect the ground wire (1)
from the socket terminal (2)
– Check the individual parts and
replace if necessary
2410RA386 TG
1
2
3
4
2410RA500 TG
2
1
Installation
: Push blade receptacle (1) onto
the straight connector tag of the
socket terminal (2) so that the
crimped side faces the angled
connector tag (3)
: Press holder (1) as far as it will go
into the guides (arrows) of the air
guide shroud
2410RA501 TG
3
1
2
2410RA502 TG
1