Operation Manual

150 MS 241 C
: Remove screw (1)
: Remove the chain catcher (2)
: Pry antivibration spring (1) out of
the bearing seat (2)
: Pull tank housing (1) out of the
crankcase (2)
Versions with QuickStop Super
– Pull out the tank housing, at the
same time pulling the brake cable
out of the crankcase
2410RA300 TG
2
1
2
2310RA410 TG
1
2
2410RA539 TG
1
All versions
– Examine the tank housing and
replace it if necessary.
Those parts of the old tank housing
which are not supplied with the new
tank housing must be reused – see
spare parts list.
– Replace fuel hoses
: Check stop buffers (1) on the
ignition and clutch sides, replace
if necessary, b 10.3.2
Installation
: Guide tank housing (1) with the
narrow part (2) in front into the
mount in the crankcase
2410RA540 TG
1
2
2410RA541 TG
1
: Press antivibration spring (1) into
the bearing seat (2) so that the
tab (3) engages in the
opening (arrow)
: Push the chain catcher (3) into
the mount so that it engages
under the bumper strip (3)
: Screw in the screw (1) and
tighten it
2
2310RA414 TG
1
3
2410RA301 TG
3
1
2