Operation Manual

146 MS 241 C
Versions with heating
: Fit the plug (1) of the antivibration
spring on the front handle
: Screw in the screw (2) and
tighten it
– Check position of the fuel hose
and correct it if necessary,
b 13.11.2
: Use hook 5910 893 8800 to pull
the fuel suction hose (1) out of
the fuel tank
Take care not to overextend the fuel
suction hose.
– Fit the pickup body, b 16
– Install air guide shroud, b 13.4
Versions with heating, b 13.4.2
2410RA307 TG
1
2
1
2410RA526 TG
– Install the carburetor support,
b 13.8
– Install the carburetor, b 13.5
– Close the filler cap
– Reassemble remaining parts in
reverse order
13.11.3 Fuel hoses manual fuel
pump
– Open the filler cap
– Remove the pickup body,
b 13.11.1
– Remove filter base, b 13.3
: Disconnect the fuel suction
hose (1) from the
connectors (arrows)
– Remove the carburetor, b 13.5
– Remove carburetor support,
b 13.8
– Remove the air guide shroud,
b 13.4.1
– Lower the tank housing,
b 13.11.2
2410RA527 TG
1
Versions with QuickStop Super
Before lowering the tank housing,
loosen the brake cable holder,
because the sleeve of the brake
cable can be pulled out of the
adjusting screw when the tank
housing is lowered
– Brake cable adjustment can be
negatively affected.
: Unscrew screw (1) pull
support (2) out of the mount
: Remove fuel hose (1),
b 13.11.2
1
2
2310RA057 TG2410RA528 TG
1