Operation Manual

144 MS 241 C
Versions with QuickStop Super
Before lowering the tank housing,
loosen the brake cable holder,
because the sleeve of the brake
cable can be pulled out of the
adjusting screw when the tank
housing is lowered
– Brake cable adjustment can be
negatively affected.
: Unscrew screw (1) pull
support (2) out of the mount
All versions
– Lower the tank housing
: Pull out fuel hose (1) with
connector
1
2
2310RA057 TG2410RA519 TG
1
: Remove connector (1) from fuel
hose (2)
– Remove the pickup body,
b 13.11.1
: Pull the fuel suction hose (1) out
of the inside of the tank
– Replace fuel hose and fuel
suction hose; check connector,
replace if necessary
Installation
: Push fuel suction hose (1) into
hole (arrow) in fuel tank
2
2310RA378 TG
1
2410RA520 TG
1
2410RA521 TG
1
– Use STIHL press fluid to simplify
assembly, b 16
: Orient the fuel suction hose (1)
and press it into the hole in the
housing as far as it will go – the
flange must be flush with the
guide (arrow)
: Orient the flat surface of the
connector (1) so that it faces the
tab of the fuel hose (2) (arrows) –
tab must rest evenly against the
connector
: Push the connector (1) into the
fuel hose (2) as far as it will go
2410RA522 TG
1
2
2310RA382 TG
1