Operation Manual

142 MS 241 C
13.10.2 Removal and installation
– Remove shroud, b 6.4
: Remove screw (1)
: Press tank housing (1)
downward and maintain spacing
by inserting wooden assembly
block (2) 1108 893 4800
: Remove cover (1)
2310RA365 TG
1
2310RA366 TG
1
2
2310RA367 TG
1
: Pry out the tank vent (1) via the
mounting rib (arrow)
Always fit a new tank vent.
– Wet O-ring of new tank vent with
STIHL press fluid, b 16
– Press the new tank vent in by
hand until it audibly engages
: Position cover (1) so that it
engages the peg (arrow)
2310RA368 TG
1
2310RA369 TG
1
: Remove wooden assembly block
and raise tank housing (1) until
the holes (arrow) in tank housing,
cover and antivibration spring
align
: Screw in the screw (1) and
tighten it
– Reassemble remaining parts in
reverse order
2310RA370 TG
1
2310RA365 TG
1