Operation Manual

137MS 241 C
: Press lead (1) into the
guides (arrows) so that is is
behind the peg (2)
: Slide on the insulating tube (3)
All versions
– Move the end cover (1) back and
forth slightly until the pegs on the
end cover engage in the holes in
the carburetor housing
– Check that the pump diaphragm
and gasket are correctly seated
: Screw in the screw (2) and
tighten it
– Reassemble remaining parts in
reverse order
13.6.4 Lead retainer
– Remove the carburetor, b 13.5
– Remove the wiring harness with
switchgear, b 8.4
2410RA374 TG
1 32
2410RA376 TG
1
2
: Remove screw (1) and pull out
cable holder (2)
Installation
: Orient the cable holder (1) so that
the closed side faces the
carburetor and the pin lines up
with the mount (arrow)
: Press in the cable (1) as far as it
will go
: Screw in the screw (2) and
tighten it
– Install the wiring harness with
switchgear, b 8.4
– Reassemble remaining parts in
reverse order
13.6.5 Lever of the throttle shaft
– Remove the carburetor, b 13.5
– Troubleshoot carburetor, b 3.6
2410RA365 TG
2
1
2410RA366 TG
1
2
: Press out the circlip (1) and
remove the lever (2)
Installation
: Orient lever (1) so that the hook
engages the lever of the choke
shaft (arrows)
: Slide the lever (1) onto the
throttle shutter shaft (2) so that it
aligns with the flat faces
: Push circlip (3) into place
: Check correct functioning
– Lever (1) must engage in
lever (4) (arrows)
– Reassemble remaining parts in
reverse order
2410RA367 TG
2
1
2410RA368 TG
3
4
1
2