Operation Manual

132 MS 241 C
All versions
: Push on the carburetor (1) further
: Orient plug (1) and jack (2) that
the tab (3) lines up with the
opening (arrow) – do not twist the
leads
: Plug connector (1) into jack (2)
until the tab (3) clicks into place
2410RA504 TG
1
2410RA188 TG
1 2
3
: Press the plug connection (1)
into the mount (2) of the
carburetor support so that the
tab (arrow) engages and snaps
into place in the recess of the
plug connection
- Plug connection (1) must be
seated firmly in the mount (2)
– Push on the carburetor as far as
it will go – pay attention to cable
routing and make sure not to
pinch any leads
Versions with heating
: Slide the heating element (1)
over the studs so that the hole
engages the pin (2)
: Orient the crimped side of the
blade receptacle (3) so that it
faces the carburetor
: Push the blade receptacle (3)
completely onto the connector
tab (arrow)
2410RA505 TG
1 2
1
2410RA258 TG
3
2
Versions with manual fuel pump
: Push the holder (1) with the fuel
pump into the mount of the air
guide shroud (2) as far as it will
go; push new fuel hose (3) onto
the connectors (arrows)
: Fuel return line (4) must be
seated completely in the
guide (5); if necessary, press the
fuel return line (4) into the
guide (5) again
3
2410RA259 TG
1
2
4
5