Operation Manual

129MS 241 C
: Push the grommet (1) into the
mount until it is flush with the
edge of the air guide shroud
– Install wiring harness in the air
guide shroud, b 7.7.2
– Install the filter base with the
attached wiring harness, b 8.4
– Reassemble remaining parts in
reverse order
13.5 Carburetor
– Pull off the filter base over the
studs and lay it aside with the
attached wiring harness, b 8.4
– Open filler cap and drain fuel tank
– Collect fuel in a clean container,
b 1
The fuel hose may only be removed
when the tank filler cap is open.
2410RA292 TG
1
: Pull holder (1) of the switchgear
over the studs (arrows) and lay it
aside
Versions with manual fuel pump
: Disconnect the fuel hose (1)
: Push out the holder (1) with the
fuel pump on the air guide
shroud (2) and lay it on top of the
air guide shroud
2410RA239 TG
1
2410RA241 TG
1
2410RA242 TG
1
2
All versions
: Pull plug connector (1) out of the
carburetor support mount (arrow)
: Hold the jack (1), press the
tab (arrow) and pull out the
plug (2) – do not tug on the leads
Version with heating
: Remove blade receptacle (1)
: Remove heating element (2)
from the studs
2410RA243 TG
1
2410RA172 TG
2 1
2
2410RA240 TG
1