Operation Manual

128 MS 241 C
: Pull in generator lead (1) and
wiring harness (2)
: Position cable lug (3) so that the
crimped side faces upward and
insert screws (4)
: Push ground wire (5) into the
guide (arrow) and tighten
screws (4)
– Press the plug connections
together completely, b 1
: Route generator lead (1) behind
the wiring harness (2)
: Slide insulating tube (3) over the
generator lead (1)
2410RA482 TG
4
4
5
1 2
3
2410RA483 TG
2
1
3
: Push together the connector (1)
and the terminal socket (2)
: Slide insulating tube (3) over the
plug connection
: Press the plug connection with
insulating tube (1) into the center
of the guide
: Route the generator lead (2) in
the guides (arrows) so that it lies
snug against the air guide shroud
and forms a loop (3) at the
insulating tube (1)
2410RA484 TG
1 2 3
2410RA485 TG
3
1
2
: Push the contact sleeve (1) into
the heating switch (2) as far as it
will go
: Press the lead (1) completely into
the guides (arrows) so that it
rests snug against the air guide
shroud
The generator lead must be routed
along the lower guide below the
lead of the heating switch.
– Install the carburetor support,
b 13.8
– Install the throttle rod, b 11.5
– Install the carburetor, b 13.5
2
2410RA486 TG
1
2410RA487 TG
1