Operation Manual

127MS 241 C
: Pull in wiring harness (1) until the
protective tube (2) rests against
the grommet
: Pull the manifold flange (1)
through the opening by the ends
of the string (2), at the same time
pressing the air guide shroud (3)
against the manifold flange
– Remove the string
– To simplify installation, coat the
grommet with STIHL press fluid,
b 16
2410RA475 TG
1
2
2410RA476 TG
1
3
2
2410RA477 TG
1
2
: Position the air guide shroud (1)
and pull the grommet of the fuel
hose (2) into the hole (arrow)
until the grommet completely
encloses the hole
: Orient the grommet (1) of the fuel
hose (2) so the the straight
side (arrow) rests against the
edge of the air guide shroud
Shown without piston and cylinder
for a better view.
The lugs (2) of the air guide
shroud (1) must engage the
mounts (arrows) of the crankcase.
2410RA478 TG
1
2
2
2410RA288 TG
2
1
: Guide the air guide shroud (1)
over the buffers (2) and push the
lugs into the mounts of the
crankcase
: Press the air guide shroud (1)
into the mount until the tab (2)
snaps into place
: Press the air guide shroud (1)
into the mount until the tab (2)
snaps into place
2410RA479 TG
12 2
2410RA480 TG
2
1
2410RA481 TG
2
1