Operation Manual

126 MS 241 C
: Push grommet (1) onto the
generator lead (2) so that the
conical area (arrow) faces the
generator – to make it easier,
twist the grommet while pushing
it on
The generator lead (1) must be
seated completely in the
guide (arrow).
: To pull the manifold flange (2)
into the hole of the air guide
shroud, place a string (1) that is
approx. 15 cm long around the
manifold flange
2410RA469 TG
1 2
2410RA413 TG
1
2410RA471 TG
2
1
– To simplify assembly, coat the
manifold flange with
STIHL press fluid, b 16
: Fit the air guide shroud (1)
: Push new fuel hose (2) through
the opening (arrow)
– To simplify installation of the
grommet, coat the outside of the
grommet with STIHL press fluid,
b 16
: Push the generator lead (1)
through the hole on the
side (arrow) and press the
grommet (2) into the hole until it
completely encloses the hole
2410RA286 TG
1
2
2410RA472 TG
1
2
The crimped side of the ground
wire (2) must face the intake elbow.
: Press holder (1) with heating
switch as far as it will go into the
guides (arrows)
: Push lead (1) with terminal
socket (2) through the right
hole (see illustration) of the
grommet (3) and pull it in until the
connector (4) has been pulled
through the grommet (3)
: Push lead (5) with terminal
socket (6) through the left
hole (see illustration) of the
grommet (3)
2410RA473 TG
1
2
2410RA474 TG
2
3
1
4
5
6