Operation Manual

120 MS 241 C
: Guide the air guide shroud (1)
over the buffers (2) and push the
lugs into the mounts of the
crankcase
: Press the air guide shroud (1)
into the mount until the tab (2)
snaps into place
: Press the air guide shroud (1)
into the mount until the tab (2)
snaps into place
– Install the carburetor support,
b 13.8
– Install the throttle rod, b 11.5
2410RA289 TG
2
1
2
2410RA290 TG
2
1
2410RA291 TG
2
1
: Push the grommet (1) into the
mount until it is flush with the
edge of the air guide shroud
– Install wiring harness in the air
guide shroud, b 7.7.2
– Install the carburetor, b 13.5
– Install the filter base with the
attached wiring harness, b 8.4
– Reassemble remaining parts in
reverse order
13.4.1 Air guide shroud,
versions with manual fuel
pump
– Remove shroud, b 6.4
– Remove fan housing, b 9.2
– Remove filter base
– Do not remove contact spring
and switch shaft, b 8.4
– Unplug the spark plug boot
– Remove wiring harness from the
air guide shroud and lay it aside
with the filter base, b 7.7.2
– Remove the carburetor, b 13.5
2410RA292 TG
1
– Remove the throttle rod, b 11.5
– Remove carburetor support,
b 13.8
: Remove fuel return line (1) at the
fuel pump (2) and pull it out of the
guides (arrows)
: Remove screws (1)
: Press the grommet (arrow) of the
fuel hose (1) downward and out
2410RA293 TG
1
2
2410RA294 TG
1 1
2410RA295 TG
1