Operation Manual

119MS 241 C
Installation
– Pull out the shutter and inspect it,
replace if necessary
: Slide the shutter (1) into the
guide until it snaps into place
: To pull the manifold flange (2)
into the hole of the air guide
shroud, place a string (1) that is
approx. 15 cm long around the
manifold flange
– To simplify assembly, coat the
manifold flange with
STIHL press fluid, b 16
1
2410RA282 TG2410RA283 TG
2
1
: Push new fuel hose (1) through
the opening (arrow)
: Pull the manifold flange (1)
through the opening by the ends
of the string (2), at the same time
pressing the air guide shroud (3)
against the manifold flange
– Remove the string
– To simplify installation, coat the
grommet with STIHL press fluid,
b 16
2410RA284 TG
1
2410RA285 TG
1
2
3
2410RA286 TG
1
2
: Pull the grommet of the fuel
hose (2) into the hole (arrow) in
the air guide shroud (1) until the
grommet entirely encloses the
hole
: Orient the grommet (1) of the fuel
hose (2) so the the straight
side (arrow) rests against the
edge of the air guide shroud
Shown without piston and cylinder
for a better view.
The lugs (2) of the air guide
shroud (1) must engage the
mounts (arrows) of the crankcase.
2410RA287 TG
1
2
2
2410RA288 TG
2
1