Operation Manual

117MS 241 C
: Use wiring tool 5910 890 4000 to
press the ground wire (1) into the
guides (arrows) so that it lies
snug against the air guide shroud
and the marking (2) is at the edge
of the guide
: Use wiring tool 5910 890 4000 to
press the short-circuit wire (1)
into the guides (arrows) so that it
lies snug against the air guide
shroud and the marking (2) is at
the edge of the guide
– Check the switching functions of
the switch shaft
2410RA270 TG
1
2
2410RA271 TG
1
2
Versions with heating
: Insert lead (1) completely in
cable guide (arrow)
– Reassemble remaining parts in
reverse order
13.4 Air guide shroud
– Remove shroud, b 6.4
– Remove fan housing, b 9.2
– Remove filter base
– Do not remove contact spring
and switch shaft, b 8.4
– Unplug the spark plug boot
: Pull plug connector (1) out of the
carburetor support mount (arrow)
2410RA169 TG
1
2410RA171 TG
1
: Hold the jack (1), press the
tab (arrow) and pull out the
plug (2) – do not tug on the leads
– Remove the carburetor, b 13.5
– Remove the throttle rod, b 11.5
– Remove carburetor support,
b 13.8
: Remove the plug (1)
: Remove diagnostic jack (1) with
bushing (2) from the
guides (arrows)
2410RA172 TG
2 1
2410RA272 TG
1
2410RA273 TG
1
2