Operation Manual

116 MS 241 C
: Remove short circuit wire (1) and
contact spring (2) from the
guides (arrows)
– Remove contact spring, b 7.7.4
– Remove switch shaft, b 11.1
– Remove filter base
: Check buffer (1), replace if
necessary, b 10.3.3
2410RA265 TG
1
2
2410RA266 TG
1 1
Installation
– Position filter base in the
carburetor space
– Install switch shaft, b 11.1
– Install contact spring, b 7.7.4
– Use STIHL press fluid to improve
assembly, b 16
: Push the pin (1) of the filter
base (2) into the hole in the
ignition side buffer (3) as far as it
will go
: Orient the filter base (1) so that
the pin (2) is below the tab (3)
2
2410RA261 TG
3
1
1
2410RA267 TG
2
3
: Press filter base (1) over the
studs (arrows) onto the
carburetor
– Use STIHL press fluid to improve
assembly, b 16
: Push the buffer (1) completely
over the pins of the filter base (2)
– the shoulder of the pin must
protrude completely from the
opposite side of the buffer
– Install the choke rod, b 11.4
1
2410RA268 TG
2
2410RA269 TG
1