Operation Manual

110 MS 241 C
11.4 Choke rod
– Remove the air filter, b 13.1
: Move switch shaft (1) to position
"
F" and pry out choke rod (2) at
the mount (arrow)
: Unhook the choke rod (2) from
the lever (3)
– Examine choke rod and replace it
if necessary
Installation
: Hook choke rod (1) into
hole (arrow) in the starter
shaft (2)
3
2410RA344 TG
1
2
2
2410RA331 TG
1
: Insert choke rod (1) in
guide (arrow)
: Move switch shaft (2) to position
"
F" and hold it there, then press
choke rod (1) completely into the
mount (arrow)
– Check correct functioning
The choke rod must be completely
snapped into place.
– Reassemble remaining parts in
reverse order
11.5 Throttle rod
– Remove handle molding and
trigger interlock, b 11.2,
QuickStop Super, b 11.3
– Remove choke rod, b 11.4
– Remove baffle, b 13.2
– Remove filter base and set it
aside, b 13.3
– Carefully pull out the carburetor
over the studs and lay it aside
– Do not overextend fuel hose,
b 8.4
2410RA345 TG
2
1
: Pry out throttle rod (1) at the
carburetor support (2)
: Guide throttle rod (1) through the
opening (arrow) in the direction
of the control handle and remove
it
– Examine the throttle rod and
replace it if necessary
Installation
: Guide throttle rod (1) between
tank housing and crankcase
through the opening (arrow) in
the direction of the carburetor
support
2
1
2310RA293 TG
1
2310RA294 TG
1
2310RA295 TG