Operation Manual

109MS 241 C
Installation
: Hook brake cable (1) into
hole (arrow) in switch lever
: Turn switch lever (2) until it faces
upwards
: Center the throttle trigger (1) with
punch (2)
: Drive in the pin (3) until it is
equidistant on both sides
– Reassemble remaining parts in
reverse order
– Check function of the switch lever
by actuating the trigger interlock
2310RA186 TG
1
2
2310RA187 TG
1
2
3
11.3.2 Trigger interlock
QuickStop Super
After each removal, coat sliding and
bearing points with grease.
– Remove handle molding, b 11.3
: Push out pin (arrow) with drift (1)
– Remove trigger interlock
: Drive out bushing (1)
: Remove torsion spring (2)
– Examine trigger interlock, throttle
trigger and bushing, replace if
necessary
2310RA188 TG
1
2310RA189 TG
1
2
Installation
: Align torsion spring (1) and insert
in trigger interlock
: Slide bushing (2) into
hole (arrow) – torsion spring is
secured
Torsion spring (arrow) must rest
against the tank housing.
: Center trigger interlock (1) with
drift (2)
: Drive in the pin (3) until it is
equidistant on both sides
– Reassemble remaining parts in
reverse order
– Check correct functioning
2
2310RA190 TG
1
2310RA191 TG
23
1