Operation Manual

108 MS 241 C
Installation
: Hook the torsion spring (1) into
the throttle trigger (2)
– Note the installed
position (arrow)
: Insert throttle trigger (1) in the
handle so that the angled end of
the torsion spring engages in the
mount (arrow) and the holes on
the throttle trigger and handle
align
The brake cable (1) must lie
completely in the guide (arrows)
and be underneath the drift – do not
damage the brake cable.
2
2310RA179 TG
1
2310RA180 TG
1
1
2310RA181 TG
: Center the throttle trigger (1) with
punch (2)
: Drive in the pin (3) until it is
equidistant on both sides
: Hook the throttle rod (1) onto the
throttle trigger (2) and hook it into
the guide (arrow)
– Grease rotor on throttle trigger,
b 16
: Hook handle molding (1) with the
tabs (2) into the openings (arrow)
– Press trigger interlock
downwards
3
2310RA182 TG
2
1
2
2310RA183 TG
1
2310RA174 TG
1 2
– Carefully fit handle molding (1)
until it snaps into place
– Check correct functioning
– Reassemble remaining parts in
reverse order
11.3.1 Trigger switch
QuickStop Super
After each removal, coat sliding and
bearing points with grease.
– Remove handle molding, b 11.3
: Push out pin (arrow) with drift (1)
: Partly remove switch lever (1)
and turn by approx. 90°, then pull
off brake cable (2)
– Examine switch lever, replace if
necessary
2310RA184 TG
1
2310RA185 TG
1
2