Operation Manual

107MS 241 C
: Press end (1) of the torsion
spring toward the handle
: Press the trigger interlock (2) into
the bearing points (arrow)
: Hook the torsion spring (1) onto
the trigger interlock (arrow)
The trigger interlock may pop out.
: Hook handle molding (1) with the
tabs (2) into the openings (arrow)
– Fit handle molding (1) until it
snaps into place
2
2310RA172 TG
1
2310RA173 TG
1
2310RA174 TG
1 2
– Check correct functioning
– Reassemble remaining parts in
reverse order
11.3 Throttle trigger / throttle
trigger interlock /
QuickStop Super
After each removal, coat sliding and
bearing points with grease.
: To disassemble the handle
molding. press the pegs (1) on
the underside apart and through
the rear hand guard
: Remove handle molding (1)
5902RA307 TG
1
1
2310RA175 TG
1
: Pull throttle rod (1) out of the
mount (arrow) and unhook it from
the throttle trigger (2)
: Push out pin (1) with drift (2)
: Remove throttle trigger (1) with
torsion spring (2)
– Check rotor on throttle trigger to
ensure that it can be rotated,
replace throttle trigger if
necessary
– Examine the torsion spring and
replace it if necessary
2
2310RA176 TG
1
1
2310RA177 TG
2
1
2310RA178 TG
2