Operation Manual

106 MS 241 C
11.2 Throttle trigger / throttle
trigger interlock
: To disassemble the handle
molding. press the pegs (1) on
the underside apart and through
the rear hand guard
: Remove handle molding (1)
The trigger interlock (arrow) may
pop out.
: Pull the trigger interlock (1) out of
the bearing points (arrows)
5902RA307 TG
1
1
2310RA165 TG
1
2310RA166 TG
1
: Pull throttle rod (1) out of the
mount (arrow) and unhook it from
the throttle trigger (2)
: Push out pin (1) with drift (2)
: Remove throttle trigger (3) with
torsion spring (4)
– Examine trigger interlock, throttle
trigger and torsion springs,
replace if necessary
Installation
: Hook the torsion spring (1) into
the throttle trigger (2)
– Note the installed
position (arrow)
2310RA167 TG
2
1
2310RA168 TG
1
2
4
3
2310RA169 TG
2
1
: Insert throttle trigger (1) into the
handle so that the tab (arrow) is
inside the handle and the holes
on the throttle trigger and handle
align
: Center the throttle trigger (1) with
punch (2)
In version with heating, the
connecting leads must be routed
entirely in the guide and must not
protrude
– Risk of leads becoming pinched,
b 14.9.
: Drive in the pin (3) until it is
equidistant on both sides
: Hook the throttle rod (1) onto the
throttle trigger (2) and hook it into
the guide (arrow)
Make certain that the torsion spring
is hooked entirely into the throttle
trigger.
2310RA170 TG
3
2
1
2310RA171 TG
2
1