Operation Manual

103MS 241 C
: Insert and tighten screws (1) –
lines must be seated in the
guide (arrow)
– Tighten screws of the front
handle on the underside of the
machine
: Push insulating tube (1) onto
lead of the heating switch
: Push connector (2) with short
lead completely into the terminal
socket (3)
– Push insulating tube entirely over
the plug connection
2410RA332 TG
1
1
2410RA333 TG
1 3 2
: Push insulating tube (1) onto
thick lead of the handle heating
: Push connector (2) with long lead
completely into the terminal
socket (3)
– Push insulating tube entirely over
the plug connection
– Lift tank housing slightly
Plug connection with longer lead of
the front handle.
: Position insulating tube (1) with
plug connection at the edge of
the tank housing and push it into
the guide (arrow) as far as it will
go
2410RA334 TG
1 3 2
2410RA336 TG
1
Plug connection with shorter lead of
the front handle.
: Press insulating tube (1) with
plug connection as far as it will go
into the guide (arrow)
– Lift the tank housing again and
hold it there
: Press insulating tube (1) with
plug connection as far as it will go
into the guide (arrow)
2410RA337 TG
1
2410RA338 TG
1