Operation Manual

102 MS 241 C
Installation
– Press the plug connection
together completely, b 1
: Press in the handle insert (1) as
far as it will go
: Screw in the screw (1) and
tighten it
: Push on plastic sleeve (2) until it
snaps into place
2410RA327 TG
1
2410RA328 TG
2
1
The leads on the front handle are of
different lengths; during assembly,
take care that the short lead (1) is
connected to the lead to the heating
switch and the long lead (2) is
connected to the lead to the handle
heating element.
– Position front handle
: Lift front handle (1) with the
peg (2) facing forward into the
recess (arrow) until it is seated in
the mount of the tank housing
– Insert screws – do not tighten
2410RA329 TG
1
2
2
2310RA158 TG
1
Do not pinch the leads and plugs.
: Lift front handle (1) slightly and
push the cover (2) into the mount
: Push the front handle (1) into the
mount (arrow)
: Orient the leads of the front
handle in the guide (arrow) so
that the long lead (1) runs
underneath the short lead (2)
The wiring harness and the
connecting leads must be located
underneath the throttle rod (3).
2410RA330 TG
2
1
2410RA335 TG
2
1
3