Operation Manual

99MS 241 C
Installation
: Orient buffers (1)
– conical pegs facing the
holes (arrows)
– To simplify installation, coat the
conical pegs with STIHL press
fluid, b 16
: Press the buffers (1) with the
conical pegs completely into the
holes (arrows) –to simplify
assembly, twist the buffers while
pressing them in
The conical pegs (arrows) must
enclose the holes completely on the
reverse.
2410RA314 TG
1 1
2410RA315 TG
: Push tank housing (1) upward
and hold it there
: Screw in the screw (2) and
tighten it
– Reassemble remaining parts in
reverse order
10.4 Front handle
– Remove shroud, b 6.4
: Remove screw (1)
– Take out screws
2310RA253 TG
2
1
2410RA302 TG
1
2410RA315 TG
1
: Lift front handle (1) slightly at the
side and remove it from the
guide (arrow).
: Remove screws (1) on the
underside of the machine and lift
front handle (2) out of the
mount (arrow)
: Remove front handle (1) from the
lower guide
– Remove and examine front
handle (1), replace if necessary
– Examine the antivibration spring
and replace if necessary, b 10.3
2310RA157 TG
1 1 2
0001RA232 TG
1