Owner's Manual

MS 201, MS 201 C
English
44
N Carefully remove broken pieces of
spring
N Apply a few drops of non-resinous
oil to the new replacement spring
N Position the replacement spring
with frame in the fan housing – the
anchor loop must be located over
the retaining lug in the fan housing
N Apply suitable tools (screwdriver,
punch, etc.) to the recesses and
push the spring into its seat in the
fan cover – the spring slides out of
the frame
N Remove the frame from the fan
housing
Version with ElastoStart
Version with Easy2Start
N Fasten spring with screw
N Reinstall rope rotor, tension rewind
spring and mount fan housing on
the crankcase
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
N Thoroughly clean the machine –
pay special attention to the cylinder
fins and air filter.
N If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
N Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
The broken pieces of spring may
still be under tension and can
spring apart unexpectedly on
removal from the housing – risk of
injury! Wear face shield and
protective gloves
0011BA035 KN
0011BA036 KN
Storing the Machine